MPC Driver V2.10

February, 2000


REQUIREMENTS
------------
Before installing the MPC driver you must first install the ESCON 
adapter.  The adapter will come with standard Windows NT drivers 
that must also be installed.  Follow the instructions provided in
the installation Guide. 

The following are the minimum required levels of adapter drivers and
firmware approved for use with this release of MPC.
   
Microsoft Windows NT:      NT Channel Drivers Version 5.5.0
ESCON Adapter Firmware:    PBSA v2.3


INSTALLATION (New) 
------------
Download and Unzip (Mpc210.zip) into the \TEMP\MPC sub-directory. 

To install the MPC driver run setup.exe from this directory and it 
will automatically step you through the installation .  After the 
installation is complete it will be necessary to shutdown and restart
Windows NT before using the MPC driver. See the Installation Guide
for more details.


INSTALLATION (Upgrade)
----------------------
Download and Unzip (Mpc210.zip) into the \TEMP\MPC sub-directory. 

Upgrading the MPC driver requires de-installation and re-installation.
Under the Control Panel open the Add/Remove Programs ICON and remove 
the MPC Driver, close, and re-boot. After re-boot run the SETUP.EXE 
program in the \TEMP\MPC sub-directory. 

NOTE: Remember to record the MPC transmission group configuration settings 
before removal, otherwise these settings will be lost.  See the Installation
Guide for more details.