Digi LAN Connect


3200 Series Print Server PROM Upgrade


All 3200 series print servers ship with 4 meg PROM chips.
(reasons for purchasing 4 meg PROM chips on the 3200 are
unsuccessful flash upgrades on both firmware banks, unable
to to flash upgrade, or would rather purchase chips than flash.

1.)  unplug power to Fastport print server
2.)  remove Phillips headed screws on front (sides of printing ports)
3.)  if MIL-43xx micro module is present then remove the Phillips headed
	screws right of the UTP port
4.)  if MIL-43xx micro module is present then gently pry on both sides
	of the rectangular plate to remove the micro module
5.)  push with finger on UTP port
6.)  don't move any jumpers
7.)  remove HIGH and LOW PROM chips with chip puller (or binder clip,
	using more pulling action than prying action)
8.)  locate LOW slot (written on board), locate cut corner on LOW prom chip,
	then evenly and firmly press the chip into place.
9.)  locate HIGH slot (written on board), locate cut corner on HIGH prom chip,
	then evenly and firmly press the chip into place.
10.) reassemble: slide in board, if MIL-43xx slide in to middle of receptor,
	if MIL-43xx replace screws on rear, front screws, network, and power


Send Replaced Prom chips by regular mail to:
	Digi International
	Technical Support Department
	Attention: Lyle Wallace
	1299 Orleans Drive
	Sunnyvale, CA. 94089

For Technical Support with any questions or comments call:
(408) 744-2751
(408) 744-2771 Fax
(408) 744-2790 Fax
support@milan.com